Time:2023-04-13 16:53:25 Browse: 120
1. the Hydraulic System Is Filled with Hydraulic Oil of Poor Quality, Which Leads to Thinning of Medium and Suspension of Impurities, Thus Causing Heating.
2. Pay Attention to the Oil Level Height and Temperature Rise at Any Time during Work. Generally, the Working Temperature of the Oil Is More Reasonable at 30-60 ℃. When the Temperature Rises Abnormally, Stop the Machine and Check the Hydraulic Pressure before Use;
3. Keep the Hydraulic Oil Clean Frequently. Filter It When Refueling and Replenishing Oil. Do Not Mix It with Other Liquids. New Equipment Should Be Replaced with New Hydraulic Oil Every Six Months Or Once a Year after It Is Used for Three Months. If You Work Continuously in High Temperature, High Humidity and High Dust, You Need to Shorten the Oil Change Cycle.
4. Parts Assembled and Disassembled with 630 Tons of Hydraulic Press Must Be Kept Clean and Free from Debris Entering Valve Block Pollution. The Components of the System Must Carefully Check and Clean the Oil Tank, Lubricating Oil Filling Tank and Pipeline to Ensure Cleanliness, No Corrosion and No Pollution.
5. According to the Rated Working Pressure, Adjust the Hydraulic Pressure 25mpa Within the Range of Actual Needs. the Working Pressure Is Not Too High, Prolong the Service Life of Water Pumps and Valves, Save Energy and Reduce the Heat System.
6. Fuel Tank the Temperature in the Working Process Should Be between 55 ℃ of Oil. If the Oil Temperature Is High, Stop Working, and Work after the Oil Temperature Is Cooled to Avoid Damaging the Pump and Seal. When the Temperature Is Lower than 20℃,N32# Anti-Wear Hydraulic Oil Is the Working Medium; If the Room Temperature Is Higher than 30℃,# N46 Anti-Wear Hydraulic Oil Should Be Selected as the Working Medium. The Oil Temperature Should Be Controlled Within the Range of 15 ~ 50℃.
7. If the Equipment Is Not Used for a Long Time, All Adjustment Knobs Should Be Relaxed to Prevent the Spring from Permanently Changing and Affecting the Performance of the Components.
8. The Four-Column Hydraulic Oil Must Be Kept Clean and Replaced Every Six Months. The First Use Time Should Not Exceed 2 Months. If the Oil Is Not Bad, the Filter Can Continue to Be Used, and the Water Tank Should Be Cleaned Regularly Oil Filter Mesh. Oil Filling at Any Time Must Be Strictly Filtered. Oil Leakage Is Not Allowed to Directly Enter the Oil Tank, and the Liquid Fuel Tank Is Not Lower than the Oil Line.
9. the Equipment Cannot Be Overloaded for a Long Time, and the Maximum Pressure of the Machine Is 3 Tons. The Pressure on the Oil Gauge Cannot Exceed
10. before Starting the Machine, Check the Circuit of the Machine and Whether There Is Leakage in the Oil Circuit. When You Shut down, You Should Lubricate and Scrub the Machine Tool with 630 Tons of Hydraulic Press.
This is the message content area, you can enter or display the message here
