How to clean up the original 315-ton hydraulic press correctly?

I. Cleaning environment selection

Since some hydraulic components are precision components, it is better to disassemble and clean the hydraulic press in the purification room. If there are special requirements or conditions are good, it is better to punch it so that the indoor pressure is greater than the outdoor pressure, to prevent the pollution of atmospheric dust, it doesn't matter if the conditions are limited. As long as the clean operation is selected for isolation, it is forbidden to be carried out in the open air, glove room or assembly room.

II. Preparation of personnel before cleaning up

315 tons of hydraulic press operators should wear work clothes and work caps that are not easy to fall off fiber, to prevent dust, hair or dandruff and fiber from falling into the hydraulic system and causing pollution, eating or smoking is strictly prohibited during cleaning.

III. Selection of hydraulic oil

Clean on the clean workbench, the hydraulic components removed from the hydraulic press should be placed in the container with lid, and inject a certain amount of hydraulic oil into it. It is strictly prohibited to put it directly on the floor, in the bench or other places, kerosene or gasoline should be used to clean the hydraulic components of the hydraulic press, as well as hydraulic oil with the same oil brand as that used in the work of the hydraulic system.

IV. Selection of wiping articles

After cleaning the hydraulic components of the hydraulic press, do not wipe them with cotton, hemp, silk or chemical fiber materials to prevent the falling fibers from polluting the system; Because there are dust particles inside the skin Tiger, therefore, it is forbidden to use the leather Tiger to blast the parts. The editor suggests that you use clean and dry compressed air to dry the parts.

V. Quick assembly after cleaning

If the cleaned hydraulic components are not in a hurry to assemble, they can be stored in anti-rust oil. If they are in a relatively humid place in the South, they should be treated with anti-rust.

• Pre：What are the reasons for the abnormal flow of 400 tons hydraulic press?
• Next：What should I do if the return speed of hydraulic cylinder of 315 tons hydraulic press is slow?