Precautions for safe operation of cattle and sheep hydraulic press

1, no work experience personnel to control the cattle and sheep licking brick hydraulic press, new employees to train after the job.

2. If any abnormality is found in the machinery and mold, it can be reported in time, and only after the repair is qualified.

3, to overcome the paralysis of irregular operation, prohibit more than two people at the same time operation of cattle and sheep licking brick hydraulic press. (Before starting, check whether the fasteners are secure, whether there are obstacles in each running part and sliding surface, and whether the limiting device and safety protection device are perfect.)

4, mechanical repair, maintenance must be cut off the power supply, pillow.

5, hydraulic machine operation, it is strictly prohibited to enter the mold cavity to repair the mold, in and out of the product to strictly pay attention to safety. Use the safety device to move the product to the side first, and then use the hand after confirming the safety.

6, the installation of the mold must be standardized, the pressure plate is pressed and then checked once, the closed height of the press should be controlled in the range of adjustment, the pressure of the press should be adjusted from small to large, the first piece must be activated.

7, tools, pressure plate, screw, screw cap, pad to light, after use to put on the shelf.

8. Fill in the lubricating oil according to the provisions of the lubrication chart, and check whether the oil quantity and oil passage are smooth and whether the oil quality is good. (It is strictly prohibited to adjust the control valve and the pressure gauge, and the pressure gauge should be corrected regularly. Maintain the oil quality of hydraulic oil, the working oil temperature should not exceed 45 ℃, if abnormal, stop.)

9. Check whether the fasteners of the cattle and sheep licking brick hydraulic press are reliable, the limiting device and the safety protection device are complete and reliable.

10. Empty stroke test run of cattle and sheep hydraulic press; Check whether the buttons, switches, valves and limiting devices are flexible and reliable; Confirm that the pressure of the hydraulic system is normal and the working beam is flexible before working.

• Pre：What Do I Need to Check before and after the Operation of 1000 Tons Hydraulic Press?
• Next：What are the reasons for the decrease of the pressure of the 315 tons single arm hydraulic press?