Time:2023-04-27 16:27:42 Browse: 120
1. If the oil temperature of the cattle and sheep licking brick hydraulic machine is too high, check whether the setting value of the pressure control valve is too high. If it is too high, reduce the working pressure of the machine
2. After the cattle and sheep brick licking hydraulic press equipment is naturally cooled, open the oil release screw plug and take an oil sample.
3. Check the viscosity index of the oil. If the viscosity is too low, it will affect the pressure index of the small hydraulic machine.
4. If the oil is obviously turbid and water is mixed in the hydraulic oil, it is recommended to replace it as soon as possible.
5. When replacing the hydraulic oil, be sure to drain all the oil in the hydraulic system of the small hydraulic machine, including the hydraulic tank, and replace it with new oil. At the same time, ensure that the hydraulic oil should not be less than 100kg each time.
6. When the hydraulic pump of the cattle and sheep licking brick hydraulic machine and its joints generate heat due to leakage, the joints should be tightened to strengthen the seal;
7. When the capacity of the oil tank of the hydraulic machine is too small and the heat dissipation conditions are poor, the capacity of the oil tank should be increased and cooling equipment should be installed;
This is the message content area, you can enter or display the message here
