Time:2023-12-10 09:55:02 Browse: 120
Considerations for Installing and Adjusting the Mold on a 200-ton Four-Column Hydraulic Press:
1.Adjustments to the Hydraulic Press Itself:
Before installation, carefully adjust the equipment's performance. Check if the hydraulic press has accumulated dust, powder, or iron debris. Perform necessary cleaning to minimize potential issues in the later stages.
2.Adjustment of the Slide Stroke for the Hydraulic Press:
Pay attention to checking the mold thickness and ensure that the upper and lower modules are proportioned correctly. The modules should ideally be controlled at the switch points of the stroke circuit, requiring careful attention to detail.
3.Adjustment of the Stroke Module for the 200-ton Four-Column Hydraulic Press:
Position the hydraulic press at its highest point, adjusting the upper limit point for the module. Set the switch when the module is at the highest position and reserve the slider's resting position. Implement a deceleration module during descent to better protect the equipment and mold.
4.Adjustment of Clearances Between Hydraulic Press Components:
Measure the distance between the upper and lower modules, and set the specific clearance based on the material being pressed.
5.Adjustment of the Angle for the Four-Column Hydraulic Press:
The angle adjustment is related to the produced product. Typically, for a 90-degree bending mold, the middle angle must be greater than the side angles. Tension can be adjusted using screws. During bending, pressure adjustment through a pressure gauge helps avoid mold edge collapse.
This is the message content area, you can enter or display the message here
