Time:2025-02-18 16:53:00 Browse: 120
CNC vertical lathe is made of high-grade cast iron and box structure design, after appropriate annealing treatment to eliminate internal stress, the material is tough, coupled with the box structure design, high rigidity of the body structure, so that the machine has sufficient rigidity and strength, the machine to show resistance to heavy cutting ability and reproducibility of high precision characteristics. The base and spindle box are of one-piece box structure, adopting thick and multi-layer rib wall design, which can effectively inhibit thermal deformation, and can be subject to static and dynamic torsion and deformation stresses, ensuring high rigidity and stability of the bed.
Maintenance of CNC vertical lathe system:
1. Strictly observe the operating procedures and daily maintenance system.
2. Prevent dust from entering the electronic control device floating dust and metal powder easily caused by the electrical components between the insulation resistance drops, thus failures or even damage to the components.
3. Clean the heat dissipation and ventilation system of the electronic control cabinet at regular intervals.
CNC vertical lathe operation precautions:
1. Entering the operation room must wear well-fitting work clothes, wearing a work cap, shirt should be tied into the trousers, open sleeves should be tightened, female operators must return the long hair into the cap.
2. Before starting the CNC vertical lathe, check whether the chuck spanner can be removed and whether the machine tool speed change handle can be in the correct position.
3. In the automatic machining process, curbed open the protective door of the machine tool.
4. It is strictly prohibited to wear gloves during operation, and the work clothes, collar and cuffs should be fastened.
5. When the institutions are running, do not change the handle. If you change the handle position, must be discontinued after stopping.
6. Clamping workpieces and tools used to adjust the tool to stop on the machine guide.
7. Curb hand or any other way to contact the spindle is rotating, workpiece or other moving parts.
8. Do not stop the installation and removal of tools while the spindle is rotating.
9. Curb hand contact with the tip of the tool and iron filings, to be disposed of with a brush and hook.
10 a job such as the need for two or more people to complete, to cooperate with each other, there must be a person as a safety, driving before the need to greet, to prevent accidents.
This is the message content area, you can enter or display the message here
