Time:2023-04-19 13:21:45 Browse: 120
1. Adjustment of 200-ton four-column hydraulic press itself.
Before installation, adjust the performance of the equipment. This process must be carried out carefully and patiently to check whether the oil Press enters dust and powder, and clean up iron debris, etc, carry out necessary cleaning, which can reduce many troubles in the later period.
2, about the adjustment of hydraulic press slider stroke.
Pay attention to check the thickness of the mold, and also pay attention to check whether the ratio of the upper and lower modules is normal. Under normal circumstances, the module should be controlled at the switch point of the travel line, which should be paid more attention.
3. Adjustment of travel module of 200-ton four-column hydraulic press.
The hydraulic press can be adjusted to the highest point, that is, the upper limit point of the module can be adjusted accordingly. When the module reaches the highest position, the switch should be set and the stop position of the slider should be reserved, at the same time, the deceleration module should be carried out in the next row to better protect the equipment and mold.
4. Adjustment of the gap between hydraulic presses.
It is mainly to measure the distance between the upper module and the lower module first, and the specific clearance setting needs to be determined according to the pressed plate.
5. Adjustment of angle of four-column hydraulic press.
The adjustment of this angle is also related to the products produced. Generally speaking, if the mold is folded at 90 degrees, then the angle in the middle must be greater than the angle on both sides, its tightness can be carried out according to the adjusting screws. When bending, the pressure can be adjusted through the pressure gauge to avoid the die from collapsing.
This is the message content area, you can enter or display the message here
