Time:2023-04-20 14:33:46 Browse: 120
1. the Adjustment of 200 Tons of Four Columns Hydraulic Press Itself.
Before Installation, Adjust the Performance of the Equipment First. This Process Must Be Carried out Carefully and Patiently to Check Whether Oil Press Machine Has Entered Dust, Powder, Iron Debris, Etc, perform Necessary Cleaning, Which Can Reduce a Lot of Trouble in the Later Period.
2. about the Adjustment of Hydraulic Press Slider Stroke.
Should Pay Attention to Check the Thickness of the Mold, but Also Pay Attention to Check Whether the Proportion of the Upper and Lower Modules Is Normal. under Normal Circumstances, the Module Should Be Controlled at the Switch Point of the Travel Line, Which Should Be Paid More Attention.
3. Adjustment of 200 Tons Four-Column Hydraulic Press Stroke Module.
You Can Adjust Hydraulic Press to the Highest Point, That Is, Adjust the Upper Limit of the Module Accordingly. When the Module Reaches the Highest Position, Set the Switch and Reserve the Remaining Position of the Slider, at the Same Time, the Deceleration Module Should Also Be Carried out in the next Line to Better Protect the Equipment and Mold.
4. about the Adjustment of the Gap between Hydraulic Press.
It Is Mainly to Measure the Distance between the Upper Module and the Lower Module First, and the Specific Gap Setting Needs to Be Determined According to the Pressed Plate.
5. about the Adjustment of Four-Column Hydraulic Press Angle.
The Adjustment of This Angle Is Also Related to the Products Produced. Generally Speaking, If the Mold Is Folded 90 Degrees, the Angle in the Middle Must Be Greater than the Angle on Both Sides, its Tightness Can Be Carried out According to the Adjusting Screw. When Bending, It Can Adjust the Pressure through the Pressure Gauge to Avoid the Mold Chipping.
This is the message content area, you can enter or display the message here
